DIY Guitar Messing About (1 Viewer)

[JohnnyRaz]

Finally putting the router away on this build

 

[JohnnyRaz]

Neck fitted: about .5mm higher on one side, but that’s not a biggy. Allignment with centre line is good which is the main thing

 

[JohnnyRaz]

Absolute point of no return - gluing the fretboard on

 

[JohnnyRaz]

And all of a sudden we have something that looks like a guitar.

 

[JohnnyRaz]

String up to test allignment - bridge is off by about 1mm, I’ll have to have a long hard think about how much I care about that before I attempt a redo.

 

[magicbastarder]

it's out in terms of being too high or too low on the body, i assume?
looking great anyway.

 

[JohnnyRaz]

it's out in terms of being too high or too low on the body, i assume?
looking great anyway.

About 1mm off centre to the bass side. I managed a fix by widening the holes slightly on one side and shimming on the other!

 

[JohnnyRaz]

For a bit of steam punk styling - I’ve converted the speed control knob from the gramaphone that the mahogany came from into a strap lug.

 

[magicbastarder]

'your amp goes to eleven? Well, let me tell you about this guitar...'

 

[JohnnyRaz]

'your amp goes to eleven? Well, let me tell you about this guitar...'

how it worked originally was intriguing - adjusting it raised or lowered a small screw, that pushed against an armature, that adjusted the diameter of rotation of one of these, which controlled the speed of the clockwork motor that ran the turntable