whats all this about? How do you balance the beater head with the bottom head? Or should I even bother trying? huh?
At present I have my rack tom and floor tom tuned a fifth apart (sort of, I think...) but the rack tom sounds lower when it rings out while the floor tom stays fairly tight and higher sounding... like the inital hit is higher on the rack, but it rings a lot lower then the floor tom...
By this point I realised I hadn't a clue what I was doing so I dampened them all over the place (both heads), which sort of helped, and I left it at that... but still, somethings amiss...
At present I have my rack tom and floor tom tuned a fifth apart (sort of, I think...) but the rack tom sounds lower when it rings out while the floor tom stays fairly tight and higher sounding... like the inital hit is higher on the rack, but it rings a lot lower then the floor tom...
By this point I realised I hadn't a clue what I was doing so I dampened them all over the place (both heads), which sort of helped, and I left it at that... but still, somethings amiss...